8400-M022-O1 Rev K Model 190 Indicator
ANNUNICATORS
The Model 190 is equipped with annunciators that are turned on to indicate that the display is
in the mode corresponding to the annunciator label or that the status indicated by the label is
active. This section describes each annunciator. Refer to the illustration below for the location
of the annunciators.
Symbol Name Description
0
ZERO This annunciator is turned on to indicate that the weight
displayed is within ± 1/4 division of true zero.
STABLE This annunciator is turned on when the weight display is
stable. When off, it means that the change in successive
weight samples is greater than the motion limits selected
during setup.
N
NET This annunciator is turned on when the displayed weight
is Net weight (Gross weight less Tare weight).
GROSS This annunciator is turned on to show that gross weight
is displayed. Gross weight will be displayed when no tare
weight is stored.
TARE This annunciator is turned on to show that the displayed
weight is the tare weight.
lb
pounds This annunciator is located to the right of the weight
display and is turned on to show that the displayed
weight unit is pounds.
oz
ounces This annunciator is located to the right of the weight
display and is turned on to show that the displayed
weight unit is ounces.
kg
kilograms This annunciator is located to the right of the weight
display and is used to indicate that the displayed unit of
weight measurement is kilograms.
g
grams This annunciator is located to the right of the weight
display and is used to indicate that the displayed unit of
weight measurement is grams.
To Next Page
Loading...
