8400-M022-O1 Rev K Model 190 Indicator
Symbol Name Description
C
COUNT This annunciator shows that the display is in the Count
mode and the value displayed is in pieces (the count
quantity) and not weight.
or
N and A
ACCUMULATOR This annunciator shows that the displayed value is the
content of the accumulator.
IN1
DIGITAL INPUT This annunciator is used to signal that a remote key
function has been activated.
Note that this annunciator is active only when the Digital
Input feature has been enabled. Refer to the
d in parameter in Setup.
OUT1
UNDER This annunciator is used to signal that the displayed
weight is less than the minimum value of acceptable
weight used in the Checkweigher feature or that
preset 1 is active.
Note that this annunciator is active only when the
Checkweigher feature or the preset feature has been
enabled. Refer to the d oUt parameter in Setup.
OUT2
ACCEPT This annunciator is used to signal that the displayed
weight is within the acceptable weight limits for the
Checkweigher feature.
That is, the weight is equal to or greater than the
minimum acceptable weight and equal to or less than the
maximum acceptable weight.
This annunciator is also used to indicate that preset 2 is
active.
Note that this annunciator is active only when the
Checkweigher feature or the preset feature has been
enabled. Refer to the d oUt parameter in Setup.
OUT3
OVER This annunciator is used to signal that the displayed
weight is equal to or greater than the minimum value of
overweight used in the Checkweigher feature
This annunciator is also used to indicate that preset 3 is
active.
Note that this annunciator is active only when the
Checkweigher feature or the preset feature has been
enabled. Refer to the d oUt parameter in Setup.
To Next Page
Loading...
