Cardinal 190 - Page 50

8400-M022-O1 Rev K  Model 190 Indicator
42
Units= (UNITS/ Key)
Press the TARE  key to show the current setting. If the setting displayed is acceptable,
press the TARE  key again to save it.
Otherwise, use the Fn/ key to toggle the setting and press the TARE  key to save it.
UnLoCd
LoCD
Key is Unlocked (Enabled)
Key is Locked (Disabled)
fUnC= (Fn/ Key)
Press the TARE  key to show the current setting. If the setting displayed is acceptable,
press the TARE  key again to save it.
Otherwise, use the Fn/ key to toggle the setting and press the TARE  key to save it.
UnLoCd
LoCD
Key is Unlocked (Enabled)
Key is Locked (Disabled)
print= (PRINT Key)
Press the TARE  key to show the current setting. If the setting displayed is acceptable,
press the TARE  key again to save it.
Otherwise, use the Fn/ key to toggle the setting and press the TARE  key to save it.
UnLoCd
LoCD
Key is Unlocked (Enabled)
Key is Locked (Disabled)
on= (ON/OFF Key)
Press the TARE  key to show the current setting. If the setting displayed is acceptable,
press the TARE  key again to save it.
Otherwise, use the Fn/ key to toggle the setting and press the TARE  key to save it.
UnLoCd
LoCD
Key is Unlocked (Enabled)
Key is Locked (Disabled)
IMPORTANT! When the ON/OFF key is locked, the display will briefly show
"LoCd" and then prompt the operator to press the following keys in this order:
PRINT,
ZERO,
Fn/,
TARE  ,
UNITS/,
NET/GROSS
If no key is pressed or the keys are pressed in the wrong order, the indicator will turn off.