Cardinal 190 - Key Lockout Status; Units= (UNITS; Key); fUnC= (Fn; Key); print= (PRINT Key)

8400-M022-O1 Rev K  Model 190 Indicator
34
Cont1= (Continuous Output on Serial Interface)
Press the TARE  key to show the current setting. If the setting displayed is acceptable,
press the TARE  key again to save it.
Otherwise, use the Fn/ key to toggle the setting and press the TARE  key to save it.
Cont1=YES Cont1=No
Continuous Output on Serial Interface
No Continuous Output on Serial Interface
If Cont1=YES (Continuous Output) is selected, an additional prompt, tYPE= will be
displayed.
If Cont1=no (No Continuous Output) is selected, proceed to the Weight-On- Demand
section.
tyPE= (Continuous Output Format)
Press the TARE  key to show the current setting. If the setting displayed is acceptable,
press the TARE  key again to save it.
Otherwise, use the Fn/ key to toggle the setting and press the TARE  key to save it.
0 = Continuous Output uses SMA format
1 = Continuous Output uses Cardinal Scoreboard format
SMA Continuous Output Format
If SMA is selected, data will be transmitted in the following format:
<lf><s><r><n><m><f><xxxxxx.xxx><uuu><cr>
Where:
lf
=
Line Feed
s
= Flags
Z= center of Zero, O = Overcap, E = zero Error,
e = weight not currently being displayed
r
=
Range
1 (always a 1)
n
=
Mode
G = Gross, T = Tare, N = Net
m
=
Motion
M = Motion, " "(blank) = no motion
f
=
Custom
Custom flag
xxxxxx.xxx
=
Weight
Ten characters including a decimal point (if any)
uuu
=
Units
lb, oz, kg, g
cr
=
Carriage Return
(hex 0D)