8400-M022-O1 Rev K Model 190 Indicator
Key Description
ZERO: The ZERO key is used to zero the weight display. Up to the
selected limit of 4% or 100% of the scale’s capacity can be zeroed. This
limit is selected during the setup and calibration of the indicator.
Note that the indicator will not respond to pressing the ZERO key unless
the weight display is stable.
When displaying a Tare weight, pressing the ZERO key will clear the
Tare value and set the display to Gross mode.
When displaying the Peak weight, pressing the ZERO key will clear
the Peak weight.
When displaying the Gross accumulator, pressing the ZERO key will
clear the Gross accumulator.
When displaying the Net accumulator, pressing the ZERO key will
clear the Net accumulator.
TARE
(Enter): The TARE
key is used during normal operation to
store the current Gross weight as the new Tare weight. The display will
change to the Net weight and the Net annunciator will turn on.
During Setup, pressing the TARE
key will display the current setting of
the parameter. Pressing the TARE
key a second time (after changing
parameter values or settings), signals the completion of the entry of data
and causes the indicator to process the data entered.
NET/GROSS: The NET/GROSS key is used to toggle between the Gross
and Net weight modes. The selected mode is indicated by turning on the
appropriate annunciator on the display.
Note that if no valid tare weight has been entered, pressing the
NET/GROSS key will cause a momentary display error (notArE) and the
indicator will remain in the Gross weight mode.
When in Hold, Count, Peak weight, Live weight, or Accumulator display
mode, press the NET/GROSS key to return the display to normal weight
display mode.
UNITS/
(Left Arrow): The UNITS/
key is used for several functions.
• In normal operation, the UNITS/
key is used to select the units in
which the weight is to be displayed. The available units of measure
("unit1", “unit2”, and "unit3") are selected in setup. The available units
include pounds, ounces, kilograms, and grams.
During setup, the UNITS/
key is used to advance the cursor left to the
next position when inputting setup parameters.
To Next Page
Loading...
