62-61753-21
CARD REMOVED, DATA NOT COPIED
The PC Card was removed before all data was copied onto the card.
CARD REMOVED, REINSERT CARD
The PC Card was removed from the card slot before the operation
was completed. Reinsert the PC Card into the card slot to perform
the operation.
CFG: =TO LOAD, TO CANCEL
A Configuration Card has been inserted into the PC Card slot. Press
the = key to load Configurations or IntelliSets into microprocessor.
CHANGE INTELLISET TO EXIT
The IntelliSleep Intelliset is active. Alternates with
"INTELLI-SLEEP MODE" at 5 second interval whether unit is running
or not.
Service mode has the refrigeration system set so that it can be
charged with refrigerant through the king valve. Press the = key to
manually exit, or wait until the charging is complete.
CHECK AT NEXT SERVICE INTERVAL
The unit needs to be checked at next service interval.
There is currently an active non-shutdown alarm in the alarm list.
Door switch indicates that trailer compartment door is not closed.
CHECK FUEL LEVEL
(Requires Optional Sensor)
The level in the fuel tank is very close to empty.
CHK WIRES FROM MICRO TO KEYPAD
There is a communication signal lost between the keypad/display and
the microprocessor. Check and test the wiring to the keypad/display
Pressing the = key while this message is being displayed will allow
user access to Component Test mode.
CONFIG ERROR, REMOVE CARD
There was an error configuring the microprocessor with the Configu-
ration PC Card. Remove the PC Card from the slot.
CONFIGS COMPLETE,= TO EXIT
The user has reached the end of the Configurations List. Pressing the
UP or DOWN ARROW key will start list over. Press the = key to exit
Configuration List.
Press the = key to enter Configuration Mode.
CONFIGURATION NOT CHANGED
New Configuration selection was not entered (saved) within the
5 second time limit.
The current set point is within a range that has been locked into the
Continuous Run mode. Start-Stop can not be selected.
CONTINUOUS RUN MODE SELECTED
The unit operating mode has been changed from Start-Stop to Con-
tinuous Run.
COPY COMPLETE, REMOVE CARD XX
A DownLoad PC Card has been inserted into the PC Card slot, and
all data from the DataRecorder has been copied onto the PC Card.
You may safely remove PC Card from the slot. XX = number of emp-
ty download slots remaining on the card.
COPY ERROR, REMOVE CARD XX
A DownLoad PC Card has been inserted into the PC Card slot and
an error occurred while the data was being copied onto the PC Card.
You may safely remove the PC Card from the slot.
XX indicates the number of empty download slots remaining on the
card.
A DownLoad PC Card has been inserted into the PC Card slot and all
data from the DataRecorder is being copied onto the PC Card.
DO NOT REMOVE THE CARD WHILE THIS MESSAGE IS BEING
DISPLAYED.
The microprocessor has stopped recording Unit Data.
The unit has gone into defrost.
The refrigerated compartment door is open forcing the unit to run in
low speed.
The initial message for Service Mode.
To Next Page
Loading...
