171
VIEWING SNAPSHOTS AND MOVIES
3. Turn on the TV and select its video input
mode.
If the TV has more than one video input, select the one
where the USB cradle is connected.
4. Press [ ] (PLAY) to turn on the camera and
enter the PLAY mode.
Pressing [ON/OFF] or [ ] (REC) will not turn on the
camera on the PLAY mode.
When the camera turns on in the PLAY mode, an image will
appear on the TV screen. The camera’s monitor screen will
not turn on.
5. Now you can perform the applicable operation
on the camera for the type of file you want to
play.
• At this point you could press the USB cradle’s [PHOTO]
button to start a slideshow (page 169).
To turn off the camera
You can turn off the camera by doing either of the following.
• Press the camera’s [ON/OFF] button.
• Press the USB cradle’s [USB] button.
IMPORTANT!
• When connecting to a TV to display images, be sure to
configure the camera’s [ ] (REC) and [ ] (PLAY)
buttons for “Power On” or “Power On/Off” (page 217).
• All icons and indicators that appear on the monitor screen
also appear on the TV screen.
You can use [DISP] to change the display contents.
• Audio is monaural.
• Certain TVs may cut off part of the images.
• Audio is initially output by the camera at maximum volume.
When you first start displaying images, set the TV volume
control at a relatively low level and then adjust it as
required.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
