190
EDITING IMAGES
IMPORTANT!
• When you edit a movie, only the result is saved. The
original movie is not retained. Once you perform an editing
operation, you will not be able to undo it.
• A movie that is shorter than five seconds cannot be edited.
• The movie editing operation is supported only for movies
that were recorded with this camera.
• You will not be able to edit a movie if the amount of
remaining memory capacity is less than the size of the
movie file you want to edit. If there is not enough memory
available, delete any files you no longer need to free up
more.
• Cutting a movie into two parts or splicing of two movies in
to a single movie cannot be performed on the camera.
1. Play back the movie you want to edit.
2. Press [SET] to pause
playback.
• Check to make sure that
“” (cut icon) is
displayed on the monitor
screen. If it isn’t, press
[SET] again.
3. Press [T].
• You could also perform the following steps in place of
steps 1 through 3 above.
1
In the PLAY mode, select the movie you want to edit
and then press [MENU].
2
On the “PLAY” tab, select “Movie Editing” and then
press [X].
4. Use [S] and [T] to select the cut operation
and then press [SET].
• To cancel movie editing, select “Cancel” and then press
[SET]. This will return to the paused movie playback
screen.
Cut icon
To Next Page
Loading...
Need help?
General
Weight and Dimensions
