• In the operation of Example 3, you input f(x) into the defining equation of g(x).
Conversely, you can also input g(x) into the f(x) defining equation. However, do not
have g(x) input into f(x), and f(x) input into g(x) at the same time. If you do, a Circular
ERROR will occur when you perform a calculation using f(x) or g(x).
Data Retention
Performing any one of the operations below causes the defining equations
registered to f(x) and g(x) to be deleted.
• Pressing
• Using the SETTINGS menu to switch the Input/Output setting
between MathI*
1
and LineI*
2
.
*
1
MathI/MathO or MathI/DecimalO
*
2
LineI/LineO or LineI/DecimalO
• Executing – [Reset] > [Settings & Data] or – [Reset] > [Initialize
All]
63
To Next Page
Loading...
