Working with Variables/Squares
Since all calculations are numerically performed, the calculations with
Variables must be assigned one value.
Assigning Variable values
To assign values to variables, the key
[
-->
]
must be used.
Value --> Variable
(
letters from A-Z with
[
ALPHA
]
- key
)
Calculating with Variables
Assigned values from 123 to the Variable A.
Total storage of the sum A+2 of the Variable B.
Indication of the value of the Variable B.
Deleting Variables
Delete a Variable through the assignment from 0.
Or performing a reset: Here, the values of the Variables are
set back to 0.
Square:
The Square under the Angle in the SETUP of each application is set:
Degree measure
(
DEG
)
, Radians
(
RAD
)
, Grads
(
GRA
)
.
Another possible use for the symbols, e.g. sin30 = 0,5:
[
OPTN
]
(
>
)
[
F5
]
(
ANGL
)
Variables / Squares
• Assign variable values: Value --> Variable
• Delete variable valuee: 0 --> Variable
• Adjusting squares: SETUP, Angle
To Next Page
Loading...
