CEA DIGITECH vision PULSE 3200 - WELDING PROCESS SELECTION Menu

7
WELDING PROCESS SELECTION Menu (PROCESS)
“DH” / “VS” CONTROL PANEL
To access the PROCESS SELECTION Menu (PROCESS) push the MENU KEY.
MENU KEY ENTER/MEM KEY
ENCODER KNOB - SX
MIG PULSE
MIG DUAL PULSE
MIG/MAG SYNERGIC
MIG/MAG MANUAL
VISION.COLD
VISION.PIPE
VISION.POWER
1011 Fe G3 SI-1 Ø 0.8 Ar 16-20% CO2
MENU KEY ENTER/MEM KEY
ENCODER KNOB - SX
VISION.POWER
VISION.ULTRASPEED
MMA
TIG LIFT
TIG LIFT PULSE
JOB
SEQUENCES
1011 Fe G3 SI-1 Ø 0.8 Ar 16-20% CO2
MENU KEY Provides access to the next menus.
ENCODER K
NOB - SX Select the welding process.
ENTER/MEM K
EY This key is used to access PRE-SETTING for the process selected.
The following processes are available:
• MIG PULSE (only DH)
• MIG DUAL PULSE (only DH)
• MIG-MAG SYNERGIC
• MIG-MAG MANUAL
• VISION.COLD (if activated)
• VISION.PIPE (if activated)
• VISION.POWER (if activated)
• VISION.ULTRASPEED (if activated)
• MMA
• TIG LIFT
• TIG LIFT PULSE
• JOB (if JOBS have been created)
• SEQUENCES (if SEQUENCES have been created)
“HT5” CONTROL PANEL (not used with DH 32 and VS 32)
It is not possible to access the PROCESS SELECTION Menu (PROCESS) via the HT5 control panel.