CEA DIGITECH vision PULSE 3200 - Info

44
RESET PROGRAM (0011)
RESET PROCESS DATA MIG/MAG SYNERGIC
DELETE ALL JOBS
COUNTER ALARMS RESET
TOTAL RESET
EXECUTE DATA PROCESS RESET?
RESET PROGRAM (0011)
RESET PROCESS DATA MIG/MAG SYNERGIC
DELETE ALL JOBS
COUNTER ALARMS RESET
TOTAL RESET
ARE YOU SURE?
RESET PROGRAM (0011)
RESET PROCESS DATA MIG/MAG SYNERGIC
DELETE ALL JOBS
COUNTER ALARMS RESET
TOTAL RESET
DATA PROCESS RESET DONE
All the functions included in this menu can be used as
follows:
• Choose the function (e.g. RESET PROCESS DATA) that
you intend to use by rotating the ENCODER K
NOB - SX.
• EXECUTE PROCESS DATA RESETTING by pushing the
DX K
EY.
• PROCEED by finalising the reset by pushing the SX K
EY or
cancel the operation by pushing the DX K
EY.
To exit the FACTORY RESET Menu and go back to the SETUP Menu:
• Push the MENU K
EY.
INFO SETUP Menu
The purpose of this menu is to allow the operator to know what version of the software has been loaded into each component
that is part of the welding plant.
To access the INFO Menu from the SETUP Menu:
• Turn the ENCODER K
NOB - SX to select the desired icon.
• Push the ENTER/MEM K
EY.
MENU KEY ENTER/MEM KEY
ENCODER KNOB - SX
POWER SOURCE SW. VERS.
WIRE FEEDER SOFTWARE VER. 1
WIRE FEEDER SOFTWARE VER. 2
ROBOT INTERFACE SW. VERS.
S/N
H04-03.04
F03-04.04-BETA0002
C04-24.00
500A
Software Description
POWER SOURCE SW. VERS.
POWER SOURCE SW. VERS.
WIRE FEEDER SOFTWARE VER. 1
WIRE FEEDER SOFTWARE VER. 2
ROBOT INTERFACE SW. VERS.
S/N
H04-03.04
F03-04.04-BETA0002
C04-24.00
500A
Indicates the version of the software loaded into the welding machine.
WIRE FEEDER SOFTWARE VERS. 1/2
POWER SOURCE SW. VERS.
WIRE FEEDER SOFTWARE VER. 1
WIRE FEEDER SOFTWARE VER. 2
ROBOT INTERFACE SW. VERS.
S/N
H03-04.00
F02-02.18
POWER SOURCE SW. VERS.
WIRE FEEDER SOFTWARE VER. 1
WIRE FEEDER SOFTWARE VER. 2
ROBOT INTERFACE SW. VERS.
S/N
H03-02.03
F02-02.17
This indicates the software version loaded in feeder 1/2, if applicable.
(continued)