14
ENCODER KNOB - V Adjusts the parameter displayed by the PARAMETER DISPLAY SCREEN - V.
GAS K
EY Activates the flow of gas.
SPECIAL FUNCTIONS (F
X) KEY
Only enables entering and exit afterwards from the SPECIAL FUNCTIONS Menu (SET UP
Fx) on the HT5 panel and not on the DH panel.
5 - WELDING
When welding takes place the fields in the displays show the same values as those included for pre-setting with the difference
that now they are those measured.
“DH” / “VS” CONTROL PANEL
Fe G3 SI-1 Ø 0.8 Ar 16-20% CO2
PROGRAM 1011
AV
217 29.4
“HT5” CONTROL PANEL (not used with DH 32 and VS 32)
To Next Page
Loading...
