41
Block type Description
LEVEL 1
BLOCK TYPE LEVEL 1
PARTIAL BLOCK
The operator can weld using the parameters set prior to the block and may make
adjustments and/or changes to the welding parameters using the knobs on the control
panels on the welding machine and the wire feeder (if fitted).
LEVEL 2
BLOCK TYPE LEVEL 2
TOTAL BLOCK
The operator can weld only using the parameters set prior to the block and cannot adjust
and/or edit the welding parameters.
USER BLOCK
BLOCK TYPE USER BLOCK
CURR./WIRE SPEED CHANGE BLOCKED
ARC LENGTH/VOLTAGE CHANGE BLOCKED
INDUCTANCE CHANGE BLOCKED
PROCESS CHANGE DISABLED
PROGRAM CHANGE DISABLED
JOB CHANGE DISABLED
MODE CHANGE DISABLED
SPECIAL FUNCTION CHANGE DISABLED
PERSONALISED BLOCK
Used to block or limit some adjustments and/or functions of the welding machine.
To exit the BLOCKS Menu and go back to the SETUP Menu:
• Push the MENU K
EY.
CONFIG SETUP Menu
The purpose of this menu is to allow the operator to select the language used for the VISION SCREEN, change the SETTINGS menu
to ADVANCED SETTINGS menu, enter advanced welding mode, set how cooling is managed, and set wire loading via the torch
button.
To access the CONFIG Menu from the SETUP Menu:
• Turn the ENCODER K
NOB - SX to select the desired icon.
• Push the ENTER/MEM K
EY.
MENU KEY ENTER/MEM KEY
ENCODER KNOB - SX ENCODER KNOB - DX
LANGUAGE ENGLISH
ADVANCED CONFIGURATION DISABLED
ADVANCED WELDING MODE DISABLED
COOLING MODE ON DEMAND
WIRE LOAD BY GUN DISABLED
WIRE LOAD SPEED 8.0 m/min
When the CONFIG Menu is open, the ENCODER KNOB - SX can be rotated to select the which of the 6 functions available is required.
This can be enabled (the operation does not require confirmation) by rotating the ENCODER KNOB - DX.
Advanced function Description
LANGUAGE
LANGUAGE ENGLISH
ADVANCED CONFIGURATION DISABLED
ADVANCED WELDING MODE DISABLED
COOLING MODE ON DEMAND
WIRE LOAD BY GUN DISABLED
WIRE LOAD SPEED 8.0 m/min
Indicates the languages that can be set for the VISION SCREEN.
As regards the procedure for selecting a language on the VISION S
CREEN see the relevant
paragraph in the manual (“Language Selection”).
(continued)
To Next Page
Loading...
