CEA DIGITECH vision PULSE 3200 - Mma; PROGRAM SELECTION Menu (PROGRAM); SPECIAL FUNCTIONS Menu (SET up Fx)

17
MMA
Select the MMA welding process by using the MENU KEY as explained on page 7.
1 - PROGRAM SELECTION Menu (PROGRAM) MMA
“DH” / “VS” CONTROL PANEL
To access the PROGRAM SELECTION Menu (PROGRAM) push the MENU KEY.
MENU KEY ENTER/MEM KEY
ENCODER KNOB - SX
PRG TYPE
ϯϬϬϬ DDZƵƟů
3100 MMA Basic
3200 MMA Cr Ni
3200 MMA Cr Ni
3/3
MENU KEY Used to access subsequent menus if there are any.
ENCODER K
NOB - SX Select the welding program.
ENTER/MEM K
EY Used to access PRE-SETTING of the program selected.
“HT5” CONTROL PANEL (not used with DH 32 and VS 32)
It is not possible to access the PROGRAM SELECTION Menu (PROGRAM) via the HT5 control panel.
2 - SPECIAL FUNCTIONS Menu (SET UP Fx) MMA
“DH” / “VS” CONTROL PANEL
To access the SPECIAL FUNCTIONS Menu (SET UP Fx) push the MENU KEY.
MENU KEY ENTER/MEM KEY
ENCODER KNOB - SX ENCODER KNOB - DX
DX KEY
DEFAULT
HOT START
3200 MMA Cr Ni
50
MENU KEY Used to access subsequent menus if there are any.
ENCODER K
NOB - SX Used to select the various SPECIAL FUNCTIONS (Fx).
ENTER/MEM K
EY
Used to access the PRE-SETTING with the changes made to the SPECIAL FUNCTIONS
(Fx).
DX K
EY
If held down for 2 seconds it makes it possible to return the value for the SPECIAL
FUNCTION (Fx) selected to the DEFAULT value.
ENCODER K
NOB - DX Used to change the selected SPECIAL FUNCTION (Fx) value.