29
WELDING MODE SELECTION LED
The LED unit indicates the welding mode saved in the JOB selected, which is coherent with
the VISION S
CREEN.
PARAMETER DISPLAY S
CREEN - V
Displays the JOB number also selected in the SEQUENCES or the value for the parameter
indicated by the PARAMETER SELECTION LED - V.
PARAMETER SELECTION K
EY - V
Scrolls the active parameters in succession, based on the type of welding process saved in
the JOB selected.
ENCODER K
NOB - V Used to scroll through the JOBS in the SEQUENCES as well.
GAS K
EY Activates the flow of gas.
SPECIAL FUNCTIONS (F
X) KEY Used to access displaying of the SPECIAL FUNCTIONS (Fx) saved in the JOB selected.
3 - PRE-SETTING JOB/SEQUENCES
WARNING: All the parameters saved within a JOB (including SPECIAL FUNCTIONS (Fx)) can be viewed but not edited!
“DH” / “VS” CONTROL PANEL
MENU KEY ENTER/MEM KEY
VISION SCREEN
SX KEY DX KEY
m/min V
11.1 33.3
013
MENU KEY ENTER/MEM KEY
VISION SCREEN
SX KEY DX KEY
mm
2.8 0
001
001
Fe G3 SI-1 Ø 0.8 Ar 16-20% CO2
1011 - Welding sequence
MENU KEY
Used to access the PROCESS SELECTION Menu (PROCESS) and subsequent menus, as
applicable.
SX KEY
Scrolls the active parameters in succession, based on the type of welding process saved in
the JOB selected.
ENTER/MEM K
EY
If held down for a period of about 3 consecutive seconds, this key allows the VISION SCREEN to
load all the parameters for the JOB onto the screen (making them available to the operator).
DX K
EY
Scrolls the active parameters in succession, based on the type of welding process saved in
the JOB selected.
To Next Page
Loading...
