CEA DIGITECH vision PULSE 3200 - Password

39
SEQ NAME # JOB
001 Welding sequence 2
002 Welding sequence 1 4
003 --- ---
004 Welding sequence 2 4
005 --- ---
006 Welding sequence 2 4
DELETE SEQ. 006?
Confirm using the SX KEY or cancel using the DX KEY.
EDITING A SEQUENCE
SEQ NAME # JOB
001 Welding sequence 2
002 Welding sequence 1 4
003 --- ---
004 Welding sequence 2 4
005 --- ---
006 Welding sequence 2 4
Select the position of the sequence to be edited using the ENCODER KNOB - SX and push the ENTER/MEM
K
EY.
The sequence to be edited will be displayed, with all already described for creating the sequence.
To exit the JOB EDIT Menu and go back to the SETUP Menu:
• Push the MENU K
EY.
PASSWORD SETUP Menu
The purpose of this menu is to allow the operator to enter a PASSWORD for accessing the SETUP Menu.
To access the PASSWORD Menu from the SETUP Menu:
• Turn the ENCODER K
NOB - SX to select the desired icon.
• Push the ENTER/MEM K
EY.
MENU KEY ENTER/MEM KEY
ENCODER KNOB - SX ENCODER KNOB - DX
VISION SCREEN
SX KEY DX KEY
SET PASSWORD
000
The VISION SCREEN can have various configurations, the meaning of which is indicated in the table below.
Diaplay VISION DESCRIPTION Meaning
000 The SETUP Menu ARE NOT protected by any PASSWORD.
*** The SETUP Menu ARE protected by any PASSWORD.
Number between 001 and 999 The SETUP Menu ARE protected by a PASSWORD and this can be seen by the
operator only because they are working inside the SETUP Menu.
ENTERING A NEW PASSWORD
STORE PASSWORD?
SET PASSWORD
011
To enter a new PASSWORD proceed as follows:
• Make sure that the VISION S
CREEN displays the text 000.
• Choose the new PASSWORD to be entered by rotating the ENCODER K
NOB - DX.
• Push the ENTER/MEM K
EY to confirm the operation of entering the PASSWORD.
• Push the SX K
EY to confirm and finalise entering of the new PASSWORD.
• To cancel the operation of entering a PASSWORD push the DX K
EY.
(continued)