25Data Results
Data Results
View Data for Specific Method
1. Install a USB in the USB port on the right side of the BLADE.
2. From the Home screen, press the Methods icon.
3. Press the method with the data to view.
4. Press the Information icon.
5. The “Details” will provide information about the method and the run data will be listed in the order they were
run (newest rst). To view data using previous revisions of the method, select the correct snapshot at the top
of the screen (located above “Details”).
6. Press the desired run data. Scroll to view the “Run Details” and “Sample Information.”
7. Press the Export icon to export data.
NOTE
If contents of the USB do not appear within ten (10) seconds, then the USB may need to be
reformatted to FAT32. Contact CEM Corporation for details.
View All Data
This will display all run data in the order it was run (newest rst). Filters can be used to sore the data by method
name, sample ID, date, etc.
1. Install a USB in the USB port on the right side of the BLADE.
2. From the Home screen, press the Data icon.
3. Select the search icon in the top right corner to search all data or select the appropriate lter(s) and then the
search icon. To remove current lters, press the lter name to de-select.
4. The “Details” will provide information about the method and the run data will be listed in the order they were
run (newest rst). To view data using previous revisions of the method, select the correct snapshot at the top
of the screen (located above “Details”).
5. Press the desired run data. Scroll to view the “Run Details” and “Sample Information.”
6. Press the Export icon to export data.
NOTE
If contents of the USB do not appear within ten (10) seconds, then the USB may need to be
reformatted to FAT32. Contact CEM Corporation for details.
To Next Page
Loading...
