ChargePoint CPF50 - Tools Needed; For Wall Mount Installations; For Pedestal Mount Installation

2
output of each station (or port) to ensure the maximum load is never exceeded.
As shipped, a CPF50 charging station provides up to 50 A of output current to each charging station.
Additional information regarding Power Management for your CPF50 stations is available at
ChargePoint.com/support/guides.
Tools Needed
• Bubble level
• #2 Phillips screwdriver
• #3 Phillips screwdriver
• Wire stripper
• Voltage tester
• T10 Security Torx driver
• Gloves
For Wall Mount Installations
• Drill
• Drill bit suitable for the type of wall material
• 21 mm (3/4 in trade size) conduit and fittings
• 3/8 in hex driver
• On a wood stud only: Stud finder
• On a wood stud only: Nut setter
• On masonry or concrete: 6 mm (1/4 in) internally threaded masonry anchors and screws rated
for at least 318 kg (700 lb) pull-out force
For Pedestal Mount Installation
• Ratchet with 3/8 in and 7/16 in sockets
• 1/2 in drive torque wrench, rated for at east 122 Nm (90 ft-lbs)
• 1 -1/16 in 6-point deep socket
• Adjustable wrench
Important: Always check local codes to ensure the installation complies with all applicable
codes and ordinances.