Configuring the Wireless Network
R81.10.X Quantum Spark 1500, 1600, 1800, 1900, 2000 Appliances Centrally Managed Administration Guide|136
n
Protected network (recommended) – Enter the relevant information in the fields.
n
Unprotected network (not recommended)
3. In the Advanced Settings section (click the arrow to expand), select the options you
want:
n
Hide the Network Name (SSID) - When selected, this wireless network name is
not automatically shown to users scanning for them. Connecting to the wireless
network can be done manually by adding the specified network name.
n
Allow Station-to-Station traffic - When selected, allows wireless stations on this
network to communicate with each other. When cleared, traffic between wireless
stations is blocked.
n
Enable MAC address filtering. If you select his option, you must enter the MAC
addresses that are allowed to access the wireless network.
4. Click Apply
Additional Configurations
To change the Wireless Network password:
1. Click Password Protected.
The Change Wireless Network Password window opens.
2. Select the Security type from pull-down menu.
3. Authenticate using: Select Password or RADIUS server from the pull-down menu.
4. For Password - Enter a new password (if want to change).
Optional: Click Show to show the characters.
5. Select if you want to Allow access from this network to local networks (wireless
network is trusted).
6. Click Apply
To configure the wireless radio settings:
1. For these fields, select options from the pull-down menu:
n
Operation mode
n
Channel width
n
Channel
n
Transmitter power
2. In the Advanced section, select the Guard Interval from the pull-down menu.
To Next Page
Loading...
