Check Point QUANTUM SPARK 1570 - Advanced Configuration; Upgrade from a Management Server

Advanced Configuration
R81.10.X Quantum Spark 1500, 1600, 1800, 1900, 2000 Appliances Centrally Managed Administration Guide|299
Advanced Configuration
This section contains information about advanced configuration, including upgrades and
restoring factory defaults.
Note - Not all topics are relevant for all appliance models.
Upgrade from a Management Server
This section explains how you can upgrade the appliance from your Security Management
Server / Domain Management Server.
You can install a firmware package in:
n
SmartConsole
n
SmartUpdate
n
SmartProvisioning
Upgrading in SmartConsole
If you manage your appliance directly in SmartConsole (and not in SmartProvisioning), then
you can install a firmware package in SmartConsole.
See the Quantum Security Management Administration Guide for your version >Chapter
"Managing Gateways" >Section "Central Deployment of Hotfixes and Version Upgrades."
1. Disconnect an external storage from the USB port of the appliance.
2. Connect with SmartConsole to the Security Management Server / Domain Management
Server.
3. From the left navigation panel, click Manage & Settings view > Package Repository,
and add the applicable package to the Package Repository.
4. From the left navigation panel, click Gateways & Servers.
5. Select the target Security Gateways for deployment.
6. From the toolbar menu, click Actions and select Install Hotfix/Jumbo.
7. In the Hotfix/Jumbo section, select Install a Specific Hotfix/Jumbo.
8. In the Gateways section, you see the targets for the selected package.
9. In the Advanced section, select Automatic.