Creating a SmartLSM Appliance Cluster
R81.10.X Quantum Spark 1500, 1600, 1800, 1900, 2000 Appliances Centrally Managed Administration Guide|67
More Information
1. Click Edit to override the settings of the template topology on each of the interfaces. For
example, select WAN and click Edit.
The interface window opens.
2. In IP Address Override, enter the actual network IP address to override the template
Network address.
3. Click OK and do the above steps again for all the interfaces.
4. Click Next.
Communication Properties
1. Select a member and click Initialize. Enter the trusted communication (SIC) details and
click OK.
2. Do this step again for the second member.
3. Click Next.
VPN Properties
1. Select how to create a VPN certificate:
n
For a CA certificate from the Internal Check Point CA, select I wish to create a
VPN Certificate from the Internal CA.
n
For a CA certificate from a third party (for example, if your organization already has
certificates from an external CA for other devices), clear this checkbox and request
the certificate from the appropriate CA server.
2. Click Next.
Finish
1. Click Finish. After the wizard finishes, wait until the SIC initialization completes. It can
take a few minutes. When it completes, you see the cluster object and its two members.
When you double-click the cluster object you can see that the topology is configured with
the actual addresses.
2. On each Quantum Spark appliance, open the WebUI Home > Security Management
page and click Fetch Policy to pull the policy immediately. Alternatively, the appliance
connects to the Security Management Server at predefined periodic intervals to pull the
policy.
To Next Page
Loading...
