Check Point QUANTUM SPARK 1570 - More Information; Communication Properties

SmartProvisioning
R81.10.X Quantum Spark 1500, 1600, 1800, 1900, 2000 Appliances Centrally Managed Administration Guide|63
More Information
1. In SmartLSM gateway, select the firmware version of the installed Check Point
appliance.
2. In Security Profile, select the relevant SmartLSM gateway profile that the SmartLSM
gateway is mapped to.
3. In OS, select the operating system of the gateway. Make sure the selection fits the
hardware type.
4. In Enable Provisioning, select this checkbox to enable this gateway to be managed with
provisioning configurations. For more information, see "Managing Device Settings" on
page69 .
5. In No Provisioning Profile, select this option if you want to enable provisioning but are
not yet ready to assign a specific profile.
6. In Provisioning Profile, select the provisioning profile to assign to this gateway, from the
list of profiles created in SmartProvisioning.
7. Click Next.
Communication Properties
In the Communication Properties page, you define an Activation Key that is used to set up
Secure Internal Communication (SIC) Trust between the SmartLSM Security Gateway and the
Security Management Server. This is the same key that you should enter in the one-time
password field of the Security Management Server Authentication page of the Check Point
appliance First Time Configuration Wizard.
To generate a key automatically:
1. Select Generate Activation Key automatically.
2. Click Generate.
The Generated Activation Key window opens.
3. Click Accept.
The two Activation Key fields show the new key in hidden text. You cannot view it in clear
text again. If you click Cancel, the generated key is discarded.