Small-Scale Deployment Installation
R81.10.X Quantum Spark 1500, 1600, 1800, 1900, 2000 Appliances Centrally Managed Administration Guide|51
Installing a Security Policy
Use this procedure to prepare the policy for automatic installation when the gateway connects.
Note - If the Quantum Spark appliance is physically set up and configured, when you
successfully complete this step, the policy is pushed to the gateway. For a list of
possible statuses, see
"Viewing the Policy Installation Status" on the next page
.
At the end of the Install Policy process, the policy status for a Quantum Spark appliance that is
not yet set up is "Waiting for first connection". This implies that trusted communication is not
yet established between the Security Management Server and the Quantum Spark appliance.
When the gateway connects it establishes trust and attempts to install the policy automatically.
To install a Security Policy in SmartProvisioning GUI:
1. Click Policy > Install from the menu.
The Install Policy window opens.
2. Select the installation targets - the Quantum Spark appliance Security Gateways on
which to install the policy and the policy components (such as Network Security or QoS).
By default, all gateways that are managed by the Security Management Server are
available for selection.
3. In the Installation Mode section, select how the Security Policy should be installed:
n
On each selected gateway independently - For an appliance in the Management
First deployment mode, only this option should be used.
n
On all selected gateways, if it fails do not install on gateways of the same version
4. Click OK.
Important - If the Quantum Spark appliance object that is defined by the
appliance is not set up and is in Waiting for first connection status, you see this
message: Installation completed successfully. This means that the policy is
successfully prepared for installation.
Continue tracking the status of the Security Policy installation with the Policy Installation and
the status bar.
To Next Page
