Check Point QUANTUM SPARK 1570 - Editing an Existing Static Route; Deleting an Existing Static Route; Enabling or Disabling an Existing Static Route

Configuring the Routing Table
R81.10.X Quantum Spark 1500, 1600, 1800, 1900, 2000 Appliances Centrally Managed Administration Guide|218
Editing an Existing Static Route
Procedure
1. From the left navigation panel, click Device.
2. In the Advanced Routing section, click the Routing Table page.
3. In the routing table, click the route.
4. Above the routing table, click Edit.
5. Change the configuration.
6. Click Apply.
Deleting an Existing Static Route
Procedure
1. From the left navigation panel, click Device.
2. In the Advanced Routing section, click the Routing Table page.
3. In the routing table, click the route.
4. Above the routing table, click Delete.
Enabling or Disabling an Existing Static Route
Procedure
1. From the left navigation panel, click Device.
2. In the Advanced Routing section, click the Routing Table page.
3. In the routing table, click the route.
4. Above the routing table, click Enable or Disable.