Managing Licenses
R81.10.X Quantum Spark 1500, 1600, 1800, 1900, 2000 Appliances Centrally Managed Administration Guide|85
Managing Licenses
The Home > License page shows the license state for the Software Blades. From this page,
the appliance can connect to the Check Point User Center with its credentials to pull the
license information and activate the appliance.
In most cases, you must first register the appliance in your Check Point User Center account
or create one if you don't already have one. A User Center account is necessary to receive
support and updates.
If you have Internet connectivity configured:
1. Go to Home > License.
2. Click Activate License.
You are notified that you successfully activated the appliance license.
If you were not able to activate the license, it may be because:
n
There is a connectivity issue such as a proxy between your appliance and the Internet.
Or
n
Your appliance is not registered.
If there is a proxy between your appliance and the Internet, you must configure the proxy
details before you can activate your license.
To configure the proxy details:
1. Click Set proxy.
2. Select Use proxy server and enter the proxy server Address and Port.
3. Click Apply
4. Click Activate License.
To Next Page
Loading...
