Deploying from a USB Drive or SD Card
R81.10.X Quantum Spark 1500, 1600, 1800, 1900, 2000 Appliances Centrally Managed Administration Guide|26
Troubleshooting Configuration Files
This section discusses the scenario where the configuration file fails and the Quantum Spark
Appliance is not fully configured.
Configuration File Error
If there is an error and the configuration file fails, the appliance is not fully configured and is no
longer in the initial default condition. The commands in the configuration file that show before
the error are applied to the appliance. You can examine the configuration log to find where the
error occurred.
When the appliance is not fully configured, the First Time Configuration Wizard shows in the
Web UI. However, not all of the settings from the failed configuration file show in the First Time
Configuration Wizard.
Best Practice - Check Point recommends that you do not use the First Time Configuration
Wizard to configure an appliance when the configuration file fails. Restore the default settings
to a partially configured appliance before you use the First Time Configuration Wizard to
ensure that the appliance is configured correctly.
To Next Page
Loading...
