Small-Scale Deployment Installation
R81.10.X Quantum Spark 1500, 1600, 1800, 1900, 2000 Appliances Centrally Managed Administration Guide|38
Workflow
1. Do
not
connect the two Quantum Spark appliances to the power source.
2. Connect the required cables.
3. On the first appliance:
a. Turn it on.
b. Configure it with the First Time Configuration Wizard.
c. Reboot it.
d. Shut it down.
Note - If you do not follow these instructions, you cannot use the
http://my.firewall URL correctly and you need to connect with the
gateway's actual IP address. (That IP address is initially 192.168.1.1 on LAN1
before you change it on the Quantum Spark appliance).
4. On the second appliance:
a. Turn it on.
b. Configure it with the First Time Configuration Wizard.
c. Reboot it.
5. Turn on the first appliance.
6. In SmartConsole:
a. Configure the cluster object.
b. Install the Security Policy on the cluster object.
7. In SmartProvisioning, manage the appliance settings for the cluster object.
Creating a Cluster for New Gateways
Note - See your Quantum Spark appliance
Getting Started Guide
for full instructions
to set up and connect the Quantum Spark appliance.
The configuration procedure consists of two parts:
1. Initial configuration of two new Quantum Spark appliance gateways
2. Creating and configuring a cluster object
To Next Page
Loading...
