Managing System Services
R81.10.X Quantum Spark 1500, 1600, 1800, 1900, 2000 Appliances Centrally Managed Administration Guide|248
Managing System Services
The Users & Objects > Services page lists the system services configured in the system. In
this page you can add new services, edit services, and delete services.
You use service objects to easily define the different network protocols. This is usually with IP
protocol and ports (used by the TCP and UDP IP protocols).
You can use these objects to define policy based routing in the Device >Routing page.
To create a new service:
1. Click New.
2. In the Service tab, enter information in the fields that apply to the type of service you
select. Note that not all fields may show:
n
Name - Enter the service's name.
n
Type - Select the service type from the list:
l
TCP
l
UDP
l
ICMP - Select this option if it is necessary to represent a specific option within
the ICMP protocol. Note that this is an advanced option.
l
Other - Select this option to represent any IP protocol other than TCP or
UDP.
n
Ports - Enter the port(s) if you selected Type - TCP or UDP. Enter a specific port
number or port range.
n
IP Protocol - Enter the IP protocol, if in the Type field you selected Other.
n
ICMP type and ICMP code - Enter the ICMP type and code that you want the
service object to represent as listed in RFC 792. This option is only relevant, if in
the Type field you selected ICMP.
n
Comments - Enter an optional comment.
n
Disable inspection for this service – Select this checkbox to disable deep
inspection of traffic matching this service. This option is only available for built-in
services.
3. Click Apply
To Next Page
