Check Point QUANTUM SPARK 1570 - Managing Active Devices; Blocking a Device Manually

Viewing System Logs
R81.10.X Quantum Spark 1500, 1600, 1800, 1900, 2000 Appliances Centrally Managed Administration Guide|263
Managing Active Devices
Important - This page is only relevant for versions up to R81.10.08. Starting in
R81.10.10, Active Devices and Wireless Active Devices are replaced by the Home
> Assets page.
The Active Devices page shows a list of the devices identified in internal networks. You can
access this page from the Logs and Monitoring tab > Status section and from the Home tab >
Monitoring section.
The table shows these columns:
n
Name - Hostname of the device.
n
IP address - IP address of the device.
Note - If a device has both IPv4 and IPv6 addresses, there is a single entry in
the table.
n
MAC Address - MAC Address of the device.
n
Device Details - Type of the device.
n
Blocked - Indicates whether the device is blocked from network activity.
n
Interface - Name of the appliance interface, to which the device is connected.
Blocking a Device Manually
Click the device to select it and click Block.