Check Point QUANTUM SPARK 1570 - Creating a Smartlsm Appliance Cluster; General Properties; Cluster Properties; Cluster Names

Creating a SmartLSM Appliance Cluster
R81.10.X Quantum Spark 1500, 1600, 1800, 1900, 2000 Appliances Centrally Managed Administration Guide|66
Creating a SmartLSM Appliance Cluster
Make sure you have a SmartLSM cluster profile defined in SmartConsole before you create a
Small Office Appliance cluster in the SmartProvisioning GUI.
To create a new SmartLSM Security Cluster:
1. Open the SmartProvisioning GUI from the SmartConsole Menu.
2. In the Devices page, right-click an empty row in the table, select New SmartLSM >
Small Office Appliance Cluster.
The SmartLSM Security Gateway General Properties page opens.
General Properties
1. Enter a unique Cluster Name Prefix (Suffix is optional).
The SmartLSM Security Cluster name is:
<prefix>cluster<suffix>.
2. In Cluster Main IP Address, enter the real external virtual IP address for your actual
gateway cluster.
3. Click Next.
Cluster Properties
1. In Version, select the firmware version for the Quantum Spark appliance.
2. In Security Profile, select the SmartLSM Cluster Profile that was created in
SmartConsole (in the example, ClusterProfile1).
3. In Enable Provisioning, select this checkbox to enable this gateway to be managed with
provisioning configurations. For more information, see "Managing Device Settings" on
page69 .
4. In No Provisioning Profile, select this option if you want to enable provisioning but are
not yet ready to assign a specific profile.
5. In Provisioning Profile, select the provisioning profile to assign to this gateway, from the
list of profiles created in SmartProvisioning.
6. Click Next.
Cluster Names
The cluster members' names are shown with the configured prefix.
Click Next.