Configuring the Routing Table
R81.10.X Quantum Spark 1500, 1600, 1800, 1900, 2000 Appliances Centrally Managed Administration Guide|216
a. Click the cell.
b. Select the required option:
n
IP Address - Enter the IPv4 address of the required next hop.
Note - This option supports the nexthop probing.
l
For the probing to work, the nexthop IP address must be on
the same subnet as one of the internal appliance interfaces
(LAN, DMZ).
n
Internet connection - Select the required Internet connection.
Note - This option does not support the nexthop probing.
n
VPN Tunnel (VTI) - Select the required VPN Tunnel Interface or the GRE
interface (you must configure it in advance).
Note - This option supports the nexthop probing.
n
Interface - Select the required Local Network interface (LAN, DMZ).
Notes:
l
In the R81.10.X releases, this option is available starting
from the R81.10.05 version.
l
This option does not support the nexthop probing.
c. Click OK.
8. Optional: In the Comment field, enter an applicable text.
9. In the Metric field, enter a value:
Notes:
n
Enter a value between 101 and 200.
n
The lower the value, the higher the
priority.
10. Optional: In the Probing method field, select the applicable option:
n
Off - route probing is disabled.
n
On - route probing is enabled.
Configure the applicable nexthop servers to probe. For example:
To Next Page
