Small-Scale Deployment Installation
R81.10.X Quantum Spark 1500, 1600, 1800, 1900, 2000 Appliances Centrally Managed Administration Guide|42
4. On the Cluster General Properties page:
a. In the Cluster name field, enter a name for the Cluster object.
b. In the Hardware field, select the correct appliance series for the Quantum Spark
appliance.
c. Click Next.
5. On the Cluster Members page:
n
In the First Member section:
a. In the Member name field, enter a name for the first Cluster Member object.
b. In the Member IPv4 address field, enter the IPv4 address for the first Cluster
Member object. By default, this must be the IPv4 address assigned to the
WAN interface.
n
In the Second Member section:
a. Clear the Define the second cluster member now check box only if you want
to check the communication and connectivity.
This allows you to complete the wizard definitions for the first cluster member
only.
b. In the Member name field, enter a name for the second Cluster Member
object.
c. In the Member IPv4 address field, enter the IPv4 address for the second
Cluster Member object. By default, this must be the IPv4 address assigned to
the WAN interface.
n
In the Secure Internal Communication section:
In the Password field, enter the same one-time password you entered in the First
Time Configuration Wizard on each appliance.
Click Next.
The wizard establishes trust between the Security Management Server and the
appliances.
Note - After trust is established, it is based on security certificates.
6. On the Cluster Interface Configuration page, define if a network interface on the
Quantum Spark appliance is part of the cluster:
This window appears for each network interface that was configured on the Quantum
Spark appliance.
To Next Page
Loading...
