Small-Scale Deployment Installation
R81.10.X Quantum Spark 1500, 1600, 1800, 1900, 2000 Appliances Centrally Managed Administration Guide|44
Configuration:
a. Enter a virtual IP Address and Net Mask for the cluster. The virtual IP address is
applied in the next policy installation.
b. Click Next.
c. To enable High Availability on the interface, select the Enable High Availability on
<name> interface checkbox.
The <name> shows the network interface defined in the Quantum Spark
appliance.
When High Availability is selected, enter a virtual IP Address and Net Mask for the
cluster. The virtual IP address is applied in the next policy installation.
d. Click Next.
e. Repeat the above steps for each defined interface.
f. Click Next.
7. On the Installation Wizard Completion page:
You see a summary of the configuration parameters you set.
If you want to configure more settings in the Cluster object, select Edit Cluster in
Advanced mode.
Click Finish.
8. The General Properties window of the newly defined object opens.
Configure the applicable settings and click OK.
9. Install the Security Policy on the cluster object.
10. Renew the dynamic IP address on the computer connected to a one of the Cluster
Members.
You can then access the Active Cluster Member in a web browser at:
http://my.firewall
To Next Page
Loading...
