Small-Scale Deployment Installation
R81.10.X Quantum Spark 1500, 1600, 1800, 1900, 2000 Appliances Centrally Managed Administration Guide|46
To create and configure the cluster in SmartConsole:
1. Use the wizard to create a new Quantum Spark appliance cluster.
2. Define the IP address as the IP address used by the existing gateway GW.
3. Define the first member with GW_2's IP address.
Important - Do not define the second cluster member using the wizard.
4. Establish trusted communication.
5. Define all the IP addresses of the clustered interfaces.
Use the existing gateway GW IP address as the virtual IP address of the cluster.
6. At the end of the wizard, select the Edit the cluster in Advanced Mode checkbox.
7. In Advanced Mode, enter all the applicable configuration settings from the GW to the
cluster object.
To reconfigure the existing Quantum Spark appliance:
1. In the WebUI, go to the GW and connect to it.
2. Reconfigure the IP addresses of the clustered interfaces with the actual IP addresses
that is used by the gateway as a member of the cluster.
Important - Downtime starts.
To Next Page
Loading...
