Setting the Management Mode
R81.10.X Quantum Spark 1500, 1600, 1800, 1900, 2000 Appliances Centrally Managed Administration Guide|82
n
To connect to the Security Management Server now, select Connect to the
Security Management Server now, enter the Security Management Server IP or
name and click Connect. When you successfully connect to the Security
Management Server, the security policy is automatically fetched and installed.
If the Security Management Server is deployed behind a 3rd party NAT device,
select Always use this IP address and manually enter the IP address the
appliance used to reach the Security Management Server. This IP address
overrides, from this point on, the automatic calculating mechanism that determines
the routeable IP address of the Security Management Server for each appliance.
If trust was established but the gateway could not fetch the policy, you can
investigate the issue with the Security Management Server administrator. When
the issue is resolved, click the Fetch Policy button that shows instead of the
Connect button.
n
To connect to the Security Management Server later, select Connect to the
Security Management Server later.
4. Click Finish.
To reinitialize trusted communication with the Security Management Server:
1. In the Security Management Server section, click Advanced to reinitialize trusted
communication.
2. Click Reinitialize Trusted Communication.
A warning message appears.
3. Click Yes.
Note - You need to coordinate this operation with the Security Management
Server administrator, as reinitialization is necessary on both sides.
Security Policy
To obtain the security policy from the Security Management Server, click Fetch Policy. This
option is available only if trust is established with the Security Management Server.
Quantum Smart-1 Cloud
Quantum Smart-1 Cloud provides full management capabilities including policy management,
log analysis, and report log retention, and increases operational efficiency.
This feature is configured in the Infinity Portal. Go here to register the new Security Gateway
and get the authentication token to enable Quantum Smart-1 Cloud on the gateway WebUI.
To Next Page
Loading...
