Chino DB650 - 4-4 AUTO;MANUAL Output Operation

[DB600] General Instruction Manual Operation screen (program operation)
- 57 -
□□
▲ SEL ↑ ↓ ▼ SEL
Pattern No. selection
Displays/sets the pattern No. for program operation start.
"
□□
"
to
"
□□
"
Pattern No. 1 to 4
(Displays only the pattern No. with "Number of steps (MODE2)"
set to non-zero value)
Setting/changing is available in the program operation RESET status only.
Setting/changing is unavailable while the program operation is running
(RUN/STOP/END).
A pattern No. with the MODE2 number of steps set to non-zero value will be
displayed. If the number of steps of all pattern No. is 0, only the pattern No. 1 is
available for selection.
[Switch to operation initial screen]
Press and hold the [MODE] key to display the screen set on the MODEt operation
initial screen.
[AUTO/MANUAL output switch]
Press and hold the [>] key to switch the output between AUTO and MANUAL.
When switch to the MANUAL output, it will be switched to the PV/OUT1 (operation
screen) automatically.
▲ SEL ↑ ↓ ▼ SEL
Program drive
Displays/sets the program drive.
" "
Program operation RESET
"
□□
"
Program operation RUN
"
□
"
Program operation STOP
"
□□
"
Program operation ADVANCE
"
□□
"
Program operation END
Setting/changing using the [

] or [

] key is restricted as follows depending on the
program drive status.
Program drive status
Switchable program drive
Program operation RESET
RUN
Program operation RUN
RESET/STOP/ADVANCE
Program operation STOP
RESET/RUN/ADVANCE
Program operation END
RESET
[Switch to operation initial screen]
Press and hold the [MODE] key to display the screen set on the MODEt operation
initial screen.
[AUTO/MANUAL output switch]
Press and hold the [>] key to switch the output between AUTO and MANUAL.
When switch to the MANUAL output, it will be switched to the PV/OUT1 (operation
screen) automatically.