[DB600] General Instruction Manual MODE 6
- 92 -
PID dead band
/
output dead band
Sets the PID dead band [PID control]/output dead band [two-position control].
Function OFF [PID control]
* For the case of two-position control (P = 0.0%), operation is
performed with the output dead band 0.1% even if 0.0% is
set.
Use the [
], [
] and [ENT] keys to set the PID dead band/output dead band.
Use the [>] key to move the cursor to the right digit.
The minimum value in two-position control (P = 0.0%) is 0.1%.
[PID dead band (PID control) operation]
・
・
・
[Output dead band (two-position control) operation]
・
・
・
* When a deviation is within the output dead band immediately after start-up, the
output will be 0.0%.
Sets the control operation.
Use the [
], [
] and [ENT] keys to set the control operation.
Use the [
], [
] and [ENT] keys to set the output preset.
Use the [>] key to move the cursor to the right digit.
[PID control]
Sets the output value immediately after starting control calculation. This output value
is output when control calculation is started in the PV = SV state such as PV start.
[P control]
Sets the output value for the case of PV = SV.
To Next Page
Loading...
