Chroma 19032 - Notes and Procedures before Operating

Electrical Safety Analyzer 19032 User’s Manual
4-6
(7) FAN: Temperature control fan. When the temperature exceeds 50°C, the fan
turns ON. When the temperature is less than 45°C, the fan turns OFF.
(8) REAR PANEL GB OUTPUT Terminal
This terminal Floating status is selectable, that is open-circuited with
front panel GB terminal.
(9) 9 Pin D Connector
All of the 9 pin D-Sub connector functions are the same as (1) Remote
I/O.
(10) Plug in SCANNER (Option):
Option (6000-01): 5 points of HV output & 3
(UL approval) sets of grounding terminals.
Option (6000-02): 3 points of HV output & 5
(UL approval) sets of grounding terminals.
Option (6000-03): 8 points of HV output.
(UL approval)
Option (6000-04): HV / LC scanner
Option (6000-05): HV / LC scanner with probe
Option (6000-06): L-N Scanner & Leakage
Current Scanner
Option (6000-07): HV / LC scanner with probe
20A
Option (6000-08): HV / LC / LAC / LDC probe
scanner 20A
Option (6000-11): 4 HV output & 4 sets of
grounding terminals
Figure 4-3
(11) RS-232 INTERFACE:
RS-232 interface. (GPIB and RS-232 interface cannot be used
simultaneously.)
4.3 Notes and Procedures before Operating
1. Before plugging in the AC power cable, ensure the fuse and voltage selector settings
match the power source being used.
2. Before turning on power, read Chapter 3 “Safety Precautions”.
3. When the power is turned on, the analyzer will automatically perform a self-test. If the
self-test indicates there is a problem, turn off the power switch and remove the power
cord.