Chroma 19032 - Remote Command Description

Electrical Safety Analyzer 19032 User’s Manual
5-10
| | | :IEC <boolean > | ON | OFF
| | | :IEC?
| | | :RJUDgment <boolean > | ON | OFF
| | | :RJUDgment?
| | | :SCREen <boolean > | ON | OFF
:TRIGger:SOURce:EXTernal:STATe <boolean > | ON | OFF
:TRIGger:SOURce:EXTernal:STATe?
5.4.2 Remote Command Description
• IEEE 488.2 Commands
*CLS
Clear Status
Clear standard event status register
Clear status bit group register except for MAV bit (bit 4).
*ESE < numeric value >
Event Status Enable
Enable standard event status register value. <metric system value>
range is 0 ∼255.
*ESE?
Event Status Enable Query
Query standard event status of device enable register. <metric system value>
range is 0 ∼255.
*ESR?
Event Status Register Query
Query standard event register value of device. After this command, the standard
event register is cleared to 0. <metric system value> range is 0 ∼255.
*IDN?
Identification Query
Query/Read basic device data (a comma separates the identification fields). It
denotes the manufacturer, device model, serial number, and firmware version
.
*OPC
Operation Complete
Operation is complete.
*OPC?
Operation Complete Query
Query Operation complete. The output format is ASCII character ”1“.
*PSC 0 | 1
Power On
Clear status of Power On.
*PSC?
Power On Query
Query Power On. The output format is ASCII character ”1“ or ”0“.