Chroma 19032 - Delete Memory; Setting Preset Parameter; Operation Methods; Simple Setting Wizard

Descriptions of Panel
4-11
4.5.3 Delete Memory
1. When title displays “MEMORY SETUP”, press the [], [] keys or the [NEXT PAGE]
Function Key to move the highlighted cursor to the memory name to be deleted.
2. Press the [DELETE] Function Key. The confirm window will then display.
3. Press the [ENTER] key to confirm or press the [EXIT] Function Key to cancel.
4.6 Setting Preset Parameter
4.6.1 Operation Methods
1. When title shows “PRESET SETUP”, press the [], [] keys to move the highlighted
cursor to the parameter item to be set.
2. Press the numeric/character key or Function Key to set the parameter.
3. Press [ENTER] to confirm or press [CLR] to reset.
4.6.2 Simple Setting Wizard
1. When title displays “PRESET SETUP”, press the [ENTER] key to move the highlighted
cursor to the parameter to be set.
2. Press the numeric/character key or Function Key to set the parameter.
3. When the highlighted cursor is on the last parameter, press [ENTER] key will go to test
parameter setting menu directly for user continuous setting.
PRESET SETUP
01.
Pass Hold :
0.5 sec
02.
Step Hold :
0.2 sec
03.
AC Freq. :
60 Hz
04.
GB Freq. :
60 Hz
05.
IEC-601 :
OFF
06.
GB Voltage :
9.0 V
07.
Auto Range :
OFF
08.
Soft. AGC :
ON
09.
Part No. :
10.
Lot No. :
11.
SERIAL No. :
0.2-99.9s
Remote
Lock
Offset
Error