Chroma 19032 - Page 74

Electrical Safety Analyzer 19032 User’s Manual
5-8
| | | :OSC
| | | | :CRANge? <MAXimun|MINimum|NOW>
| | | | :CURRent<m>
| | | | | :OFFSet <numeric value>
| | | | | :OFFSet?
| | | | :LIMit
| | | | | [:OPEN] < numeric value >
| | | | | [:OPEN]?
| | | | | :SHORt < numeric value >
| | | | | :SHORt?
| | | | :CHANnel
| | | | | [:HIGH] < channel list >
| | | | | [:HIGH]?
| | | | | :LOW < channel list >
| | | | | :LOW?
| | | | :CSTandard <range>,<numeric value>
| | | | :CSTandard?
| | | :LC (6000-04, 6000-05,6000-06, 6000-07 and 6000-08 only)
| | | | :CURRent
| | | | | :OFFSet
| | | | | | [:LC] <numeric value>
| | | | | | [:LC]?
| | | | | | :LAC <numeric value> ( 6000-08 only )
| | | | | | :LAC? ( 6000-08 only )
| | | | | | :LDC <numeric value> ( 6000-08 only )
| | | | | | :LDC? ( 6000-08 only )
| | | | [:DEVice] UL1950 | UL1563 | UL544NP | UL544P | UL2601
| | | | | 1950-U1 |2601-U1 (1950-U1, 2601-U1 6000-08 only)
| | | | [:DEVice]?
| | | | :DISPlay RMS | PEAK ( 6000-08 only )
| | | | :DISPlay?
| | | | :LAC[:HIGH] <Range 0 ~ high limit, 0 means off> (6000-08 only)
| | | | :LAC[:HIGH]? (6000-08 only)
| | | | :LDC[:HIGH] <Range 0~1mA, if high limit is lower than 1mA, range
is 0~high limit, 0 means off> (6000-08 only)
| | | | :LDC[:HIGH]? (6000-08 only)
| | | | :LINE NORmal | REVerse | SFNormal | SFReverse
| | | | :LINE?
| | | | :METEr L | P , P | G (6000-05/07/08 only)
| | | | :METEr? (6000-05/07/08 only)
| | | | :GSWItch < boolean > | ON | OFF (6000-05/07/08 only)
| | | | :GSWItch? (6000-05/07/08 only)
| | | | :LIMit
| | | | | [:HIGH] < numeric value >
| | | | | [:HIGH]?
| | | | | :LOW < numeric value >
| | | | | :LOW?
| | | | :TIME
| | | | | [:TEST] < numeric value >
| | | | | [:TEST]?
| | | | | :DWELl < numeric value >
| | | | | :DWELl?
| | | | :POWer
| | | | | :MODE VOLTage | CURRent | VA | SIMUlation | SOURce
| | | | | :MODE?
| | | | | :VOLTage
| | | | | | [:LIMit]