Remote Operation
Description: This command can only be used under control of USB and Ethernet.
If SYST:REM is programmed, the 63200A will be set in the
REMOTE state, and the front panel of frame will be disabled except
the <LOCAL>key pressed.
Setting Syntax: SYSTem:REMote
Setting Parameters: None
Setting Example: SYST:REM
SYSTem:LOCal
Type: All Channels
Description: This command can only be used under control of USB and Ethernet.
If SYST:LOC is programmed, the 63200A will be set in the LOCAL
state, and the front panel will work.
Setting Syntax: SYSTem:LOCal
Setting Parameters: None
Setting Example: SYST:LOC
To Next Page
Loading...
