68
FORGE Batch Application Generator User Guide
Verify Check Digit Select one of the three calculation formulas to verify the
check digit. If the check digit
is incorrect, the barcode will
not be accepted.
Single Modulo 10
Double Modulo 10
Modulo 11 & 10
Single Modulo
10
Transmit Check Digit Decide whether to include the check digit
in the data being
transmitted.
Last digit not transmitted
Both digits transmitted
Both digits not transmitted
Both digits
transmitted
Select Length
One or two fixed lengths
Range
0~127
Negative Barcode Disable
Plessey Disable
Convert to UK Plessey When applied, each occurrence of the character "A" in the
barcode data will be replaced by the character "X".
No
Transmit Check Digit Decide whether to include the two check
digits in the data
being transmitted.
Yes
Telepen Disable
Original Telepen
(Numeric)
The original Telepen includes numeric characters. Yes
AIM Telepen (Full
ASCII)
AIM Telepen (Full ASCII) includes all the alphanumeric and
special characters.
No
GS1 Databar-14/Expanded Disable
GS1
Databar-14
Transmit
Code ID
Decide whether to include Code ID ("]e0") will be included
in the data being transmitted.
GS1
Databar
Expanded
Transmit
Code ID
Refer to GS1 Databar -14.
Yes
Transmit Application
ID
Decide whether to include the Application ID ("01") in the
data being transmitted.
Yes
Transmit Check Digit Decide whether to include the check digit
in the data being
transmitted.
Yes
GS1 Databar Limited Disable
Transmit Code ID Refer to GS1 Databar -14. Yes
Transmit Application
ID
Refer to GS1 Databar -14. Yes
Transmit Check Digit Refer to GS1 Databar -14. Yes
EAN-8 Enable
Convert to EAN-13 The EAN-8 barcode will be expanded into EAN-13, and the
next processing will follow the settings configured for
EAN-13.
No
To Next Page
Loading...
Need help?
General