107
Chapter 6 Using Reader Configuration Utility
1D LINEAR IMAGER SETTINGS
Decode Timeout Sets the maximum time (configurable from 1 to 9 sec) for the
decoding process during a scan attempt.
3 sec
Redundancy Level
Sets how many successful readings should be done before
linear barcodes such as Codabar, MSI, and Interleaved 2 of 5
can be decoded. Levels 1 to 4 available.
The readings needed for each level are as follows:
1
The following barcodes must be successfully
read twice before being decoded: Codabar,
MSI, Industrial 25 (Discrete 25), Interleaved
25.
2 All barcodes must be successfully read twice
before being decoded.
3 All barcodes must be successfully read twice
before being decoded, except for the following
which must be read three times: MSI,
Industrial 25 (Discrete 25), Interleaved 25.
4 All barcodes must be successfully read three
times before being decoded.
Level 1
Scan Mode Sets the reader’s scanning behavior.
“Continuous”
to decode the same barcode repeatedly or decode
different barcodes in a continuous motion.
“Level” for scanning by pressing the scan trigger.
Level
Timeout Between
Symbols
Sets the time for the barcode reader to resurrect its ability to
once more decode a barcode it just decoded.
Only available for Continuous mode.
1 sec
Addon Redundancy Functions when “auto-discriminate” is applied
addons. Decides the number of times of supplemental decoding
of the same barcode in order to
Configurable between 2 and 30.
10
To Next Page
Loading...
