Cisco 4000 Series User Manual

4-16
Hardware Installation Guide for Cisco 4000 Series Integrated Services Routers
OL-32185-02
Chapter 4 Configure Initial Router Settings on Cisco 4000 Series ISRs
Perform Initial Configuration on Cisco 4000 Series ISRs
Configure Virtual Terminal Lines for Remote Console Access
Virtual terminal (vty) lines are used to allow remote access to the router. This section shows you how to
configure the virtual terminal lines with a password, so that only authorized users can remotely access
the router.
By default, the router has five virtual terminal lines. However, you can create additional virtual terminal
lines. See the Cisco IOS XE Dial Technologies Configuration Guide at
http://www.cisco.com/en/US/docs/ios/dial/configuration/guide/2_xe/dia_2_xe_book.html.
Line passwords and password encryption is described in the Cisco IOS XE Security Configuration
Guide: Secure Connectivity document available at the following URL:
http://www.cisco.com/en/US/docs/ios/ios_xe/sec_secure_connectivity/configuration/guide/2_xe/sec_se
cure_connectivity_xe_book.html. See the Security with Passwords, Privilege Levels, and Login
Usernames for CLI Sessions on Networking Devices section. If you want to secure the virtual terminal
lines (vty) with an access list, see the Access Control Lists: Overview and Guidelines.
SUMMARY STEPS
1. enable
2. configure terminal
3. line vty line-number [ending-line-number]
4. password password
5. login
6. end
7. show running-config
8. From another network device, attempt to open a Telnet session to the router.
DETAILED STEPS
Command or Action Purpose
Step 1
enable
Example:
Router> enable
Enables privileged EXEC mode. Enter your password if
prompted.
Step 2
configure terminal
Example:
Router# configure terminal
Enters global configuration mode.
Step 3
line vty line-number [ending-line-number]
Example:
Router(config)# line vty 0 4
Starts the line configuration command collection mode for
the virtual terminal lines (vty) for remote console access.
• Make sure that you configure all vty lines on your
router.
Note To verify the number of vty lines on your router, use
the line vty ? command.

Cisco 4000 Series Specifications

General

Category	Network Router
Product Type	Router
Form Factor	Rack-mountable
Connectivity Technology	Wired
Product Family	Cisco 4000 Series
Operating System	Cisco IOS XE
Dimensions	Varies by model
Weight	Varies by model
Model	Cisco 4000 Series
WAN Ports	Varies by model
LAN Ports	Varies by model
Storage	Varies by model
Redundancy	Varies by model
Security Features	Varies by model
Network Management	Varies by model
Data Link Protocol	Ethernet, Fast Ethernet, Gigabit Ethernet
Network/Transport Protocol	TCP/IP, UDP
Features	Varies by model
Interfaces	Varies by model
Models	Varies
Network Interfaces	Varies by model
Power Supply	Varies by model
Virtualization Support	Yes