Cisco 4000 Series - Remove Poe Converter Power Supply; Install the Poe Power Supply Slot Filler

5-59
Hardware Installation Guide for Cisco 4000 Series Integrated Services Routers
OL-32185-02
Chapter 5 Install and Upgrade Internal Modules and FRUs
PoE Converter Power Supply Unit
Remove PoE Converter Power Supply
Step 1 Remove the bezel and fan try from the router chassis.
Open the slot latch. See Figure 5-47 for details.
Step 2 Remove the PoE converter power supply module.
Step 3 Replace PoE converter power supply filler. See “Remove PoE Power Supply Slot Filler” section for
details.
After you remove the PoE converter PSU, you need to either install a replacement power or put the filler.
Install the PoE Power Supply Slot Filler
You cannot keep the slot empty, you need to install the filler.
Step 1 Remove the bezel and fan tray from the router.
Step 2 Insert the filler tab into the slot on the chassis.
Step 3 Tighten the screws into the securing nuts on the chassis. See Figure 5-46 for details.