Cisco 4000 Series User Manual

5-77
Hardware Installation Guide for Cisco 4000 Series Integrated Services Routers
OL-32185-02
Chapter 5 Install and Upgrade Internal Modules and FRUs
Install and Remove SFP Modules
Install SFPs
Laser Safety Guidelines
Optical SFPs use a small laser to generate the fiber-optic signal. Keep the optical transmit and receive
ports covered whenever a cable is not connected to the port.
Warning Invisible laser radiation may be emitted from disconnected fibers or connectors. Do not stare into
beams or view directly with optical instruments. Statement 1051
Warning Ultimate disposal of this product should be handled according to all national laws and regulations.
Statement 1040
To install an SFP module in your router:
Step 1 Read the “Safety Warnings” section on page 5-2 section, and disconnect the power supply before you
replace any module.
Step 2 Slide the SFP into the router connector until it locks into position (see Figure 5-56).
Tip If the SFP uses a bale-clasp latch (see Figure 5-56), the handle should be on top of the SFP module.
Figure 5-56 Install an SFP Module
Caution Do not remove the optical port plugs from the SFP until you are ready to connect cabling.
Step 3 Connect the network cable to the SFP module.
94126

Cisco 4000 Series Specifications

General

Category	Network Router
Product Type	Router
Form Factor	Rack-mountable
Connectivity Technology	Wired
Product Family	Cisco 4000 Series
Operating System	Cisco IOS XE
Dimensions	Varies by model
Weight	Varies by model
Model	Cisco 4000 Series
WAN Ports	Varies by model
LAN Ports	Varies by model
Storage	Varies by model
Redundancy	Varies by model
Security Features	Varies by model
Network Management	Varies by model
Data Link Protocol	Ethernet, Fast Ethernet, Gigabit Ethernet
Network/Transport Protocol	TCP/IP, UDP
Features	Varies by model
Interfaces	Varies by model
Models	Varies
Network Interfaces	Varies by model
Power Supply	Varies by model
Virtualization Support	Yes