1-10
Cisco ASA Series CLI Configuration Guide
Chapter 1 Getting Started with Application Layer Protocol Inspection
Configuring Application Layer Protocol Inspection
esmtp [map_name] If you added an ESMTP inspection policy map according to
“Configuring an ESMTP Inspection Policy Map for
Additional Inspection Control” section on page 1-33,
identify the map name in this command.
ftp [strict [map_name]] Use the strict keyword to increase the security of protected
networks by preventing web browsers from sending
embedded commands in FTP requests. See the “Using the
strict Option” section on page 1-11 for more information.
If you added an FTP inspection policy map according to
“Configuring an FTP Inspection Policy Map for Additional
Inspection Control” section on page 1-12, identify the map
name in this command.
gtp [map_name] If you added a GTP inspection policy map according to the
“Configuring a GTP Inspection Policy Map for Additional
Inspection Control” section on page 1-4, identify the map
name in this command.
h323 h225 [map_name] If you added an H323 inspection policy map according to
“Configuring an H.323 Inspection Policy Map for
Additional Inspection Control” section on page 1-6, identify
the map name in this command.
h323 ras [map_name] If you added an H323 inspection policy map according to
“Configuring an H.323 Inspection Policy Map for
Additional Inspection Control” section on page 1-6, identify
the map name in this command.
http [map_name] If you added an HTTP inspection policy map according to
the “Configuring an HTTP Inspection Policy Map for
Additional Inspection Control” section on page 1-16,
identify the map name in this command.
icmp —
icmp error —
ils —
im [map_name] If you added an Instant Messaging inspection policy map
according to “Configuring an Instant Messaging Inspection
Policy Map for Additional Inspection Control” section on
page 1-21, identify the map name in this command.
ip-options [map_name] If you added an IP Options inspection policy map according
to “Configuring an IP Options Inspection Policy Map for
Additional Inspection Control” section on page 1-25,
identify the map name in this command.
ipsec-pass-thru [map_name] If you added an IPsec Pass Through inspection policy map
according to “IPsec Pass Through Inspection” section on
page 11-64, identify the map name in this command.
Table 1-2 Protocol Keywords
Keywords Notes
To Next Page
Loading...
Need help?
General
