1-5
Cisco ASA Series CLI Configuration Guide
Chapter 1 Configuring EIGRP
Customizing EIGRP
To enable the ASA as an EIGRP stub routing process, perform the following steps:
Detailed Steps
Note A stub routing process does not maintain a full topology table. At a minimum, stub routing needs a
default route to a distribution router, which makes the routing decisions.
Customizing EIGRP
This section describes how to customize the EIGRP routing and includes the following topics:
• Defining a Network for an EIGRP Routing Process, page 1-6
• Configuring Interfaces for EIGRP, page 1-7
• Configuring the Summary Aggregate Addresses on Interfaces, page 1-9
• Changing the Interface Delay Value, page 1-10
• Enabling EIGRP Authentication on an Interface, page 1-10
• Defining an EIGRP Neighbor, page 1-12
Command Purpose
Step 1
router eigrp as-num
Example:
hostname(config)# router eigrp 2
Creates an EIGRP routing process and enters router configuration
mode for this EIGRP process.
The as-num argument is the autonomous system number of the
EIGRP routing process.
Step 2
network ip-addr [mask]
Example:
hostname(config)# router eigrp 2
hostname(config-router)# network 10.0.0.0
255.0.0.0
Configures the interfaces and networks that participate in EIGRP
routing. You can configure one or more network statements with
this command.
Directly connected and static networks that fall within the defined
network are advertised by the ASA. Additionally, only interfaces
with an IP address that fall within the defined network participate
in the EIGRP routing process.
If you have an interface that you do not want to have participate
in EIGRP routing, but that is attached to a network that you want
advertised, see the section “Configuring Passive Interfaces”
section on page 1-8.
Step 3
eigrp stub {receive-only | [connected]
[redistributed] [static] [summary]}
Example:
hostname(config)# router eigrp 2
hostname(config-router)# network 10.0.0.0
255.0.0.0
hostname(config-router)# eigrp stub
{receive-only | [connected]
[redistributed] [static] [summary]}
Configures the stub routing process. You must specify which
networks are advertised by the stub routing process to the
distribution router. Static and connected networks are not
automatically redistributed into the stub routing process.
To Next Page
Loading...
Need help?
General
